This post will cover the last three steps in the surface subgrade creator. Step 10 checks to see if a “FGSurface Subgrade” exists in the drawing. If it does then the “FGSurface-Type” is pasted into it. If it doesn’t exist then Step 11 is needed and the surface is created and the "FGSurface” and “FGSurface-Type” is pasted into it.
Step 11:
The last step is to end the command.
Well the last step is to make sure that the program works as required, and I’ll do that in the next post.
No comments:
Post a Comment